博客

湿度,冷凝点和最大可实现的VH2O2

Humidity effect on condensation in vaporized hydrogen peroxide bio-decontamination
乔尼·帕坦森(Joni Partanen)
产品经理
Published: oct 26, 2021
Life Science

该博客是四部分系列中的第一个,我们描述了过程参数如何影响凝结和VH期间最大可实现的过氧化氢浓度2o2bio-decontamination applications.

在本系列中,我们提出了四个基本过程参数规则。但是在我们解决影响冷凝和最大可实现VH的第一个参数之前2o2ppm, we will review two important values: relative humidity and relative saturation.

Because water (H2O)和过氧化氢(H2o2)具有相似的分子结构,两者都会影响空气的冷凝点。但是,相对湿度(RH)仅表示在给定温度下空气中的水蒸气水平,而相对饱和表示空气中的水蒸气和过氧化氢蒸气的水平。在含有过氧化氢蒸气的空气中,将在100%相对湿度之前发生凝结。因此,可以通过相对饱和度(RS)测量可靠地预期冷凝点。

When relative saturation reaches 100 %RS, the vapor mixture will condense. Relative humidity and relative saturation differ whenever there is vH2o2当前和RH和RS之间的差异进一步受VH的影响2o2当前的。一旦发生凝结(相对饱和已达到100%Rs),PPM VH2o2不能再增加了。实际上,H2O2蒸气浓度通常会随着一些VH而降低2o2冷凝后将分解成水和氧气。发生这种情况时,更多的VH2o2必须注射以补偿。


If there is dripping condensation by the end of the decontamination phase, vH2o2ppm读数最初可能会在充气期间增加,因为液滴释放VH2o2back into the air.

这使我们成为第一个规则:降低初始湿度会增加在冷凝之前可以使用的H2O2蒸气的量。

下图表明,当相对湿度在调节阶段开始时(因为未进行除湿型)时,凝结会在净化过程中更快。因此,调理开始时的相对湿度越低,最大可实现的PPM VH越高2o2before condensation occurs.

在净化阶段,一些VH2o2will decompose into water and oxygen. The amount of vH2o2分解将取决于以下条件:材料,温度,湿度和气流。必须测量在某些条件下预期的实际分解。在以下图中,我们假设VH的10%2o2has decomposed from its initial value and more H2o2蒸发以补偿。

Image
VHP生物污染过程中的相对湿度

Image
VHP生物污染过程中的相对湿度Concentration Solution 59%-m

如图所示,在调节之前的除湿会影响最大可实现的PPM VH2o2。在图1a和1b中,所使用的过氧化氢溶液为12%-m;图1C和1D使用59%-m的浓度溶液。图1a和1b显示了两个原本相似的生物污染周期。橙色线表示没有除湿阶段的过程,而调节阶段则是相对湿度在50%RH时开始的。蓝线显示了在调节阶段之前完成除湿为10%RH的过程。

图1A和1C显示了除湿百分比的影响 - 在调理和停留相期间,相对湿度和相对饱和表示湿度百分比。图1B和1D显示了除湿过程对条件和停留相期间最大可实现的过氧化氢蒸气的影响。

In our second blog in this series, we will illustrate how the H2o2solution affects the amount of H2o2vapor that can be used before condensation occurs.
要阅读这些博客所依据的完整白皮书,请访问此网页:“”Considering Condensation: Influences in Hydrogen Peroxide Vapor Bio-decontamination透明

评论

Jaime Lopez Ochoa

Dec 1, 2021
I need catalog

Vaisala

Dec 3, 2021
亲爱的Jaime,您会在这里找到Vaisala目录:https://www.dacbvr.tw/en/industrial-product-catalog

Rolando Martell Aedo

2021年12月8日
he relative saturation point in a clean room varies from site to site within the premises. In the qualification I must monitor the reach of this saturation point after the nebulization or conditioning stage (time and contact), at each site where I sample with the bioindicator. In other words, I must use several probes in the measurement according to sampling stations with bioindicator. To correlate.

桑娜·莱蒂宁(Sanna Lehtinen)

Dec 21, 2021
亲爱的Rolando,是的,您绝对正确的温度以及相对饱和度和相对湿度可能会在站点内有所不同。如果我们想在温度差异的环境中避免在VH2O2生物污染过程中凝结,我们必须知道什么是最低温度。如果我们不知道这一点,我们建议使用HPP272探针测量混合露点TD,并使用其他温度传感器在不同位置测量温度。如果测量的温度等于或低于混合露点,则可能会有凝结。

布鲁诺·阿兹(Bruno Aze)

2022年1月6日
Hi ,
您是否有有关传感器的测量采集时间的数据?

乔尼·帕坦森(Joni Partanen)

Jan 19, 2022
嗨,布鲁诺,
HPP270 products have a response time of the 70s (τ63%), meaning that if there is a step-change in the H2O2 concentration, let’s say from 0 ppm to 500 ppm, the reading will be 63% of the final reading (~315 ppm) after 70 seconds and 90% of the final reading (450 ppm) in 200 seconds.
最好的问候,乔尼

Naci Sivri

Jan 25, 2022
Dear Joni,
Thanks for your work. We use your HPP270 sensors happily in our production. We have different values for min vppm levels for room biodecontainment. Which ppm level do you advice for BSL-3 Labs?
Regards

乔尼·帕坦森(Joni Partanen)

2022年2月16日
Dear Naci,

our expertise in bio-decontamination is in the measurement of vaporized hydrogen peroxide concentration and relative saturation. These parameters will enable accurate and reproducible process control. However, determination or recommendation of the suitable concentration and exposure time requires microbiological expertise and empirical testing in the actual application. This is unfortunately beyond our competence.

最好的问候,乔尼

添加新评论